Results 1 to 10 of 32

Thread: S&W Model 19 cylinder stuck

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #16
    Join Date
    Jan 2010
    Posts
    129
    Feedback Score
    0
    Quote Originally Posted by Dienekes View Post
    https://www.brownells.com/gunsmith-t...prod26886.aspx

    I have one of these; works fine. However you can get by with a small vise and leather pads to hold the tip of the rod while you tighten it (LH threads!) No need to over do it--just snug it up. I used to put some blue loc-tite on those threads and that was the end of that problem.
    Alternatively: https://www.brownells.com/gunsmith-t...prod26662.aspx

    The small vice is a good alternative as well.

    I think the key here is the 242.
    Using loctite is a bandaid for a worn extractor / extractor rod. Correct torque will prevent the rod from coming loose.

    It's also worth pointing out that these are not loctited from the factory, never have been AFAIK. And the only time they come loose is after someone removes them then doesn't torque them back down properly.
    Last edited by jh9; 06-07-19 at 14:30.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •