So I was doing my monthly AR checkup today, being a holiday and all. I noticed on one of my factory BCM lowers that the RE has several "cracks" or machining marks all around it. I wiped down the RE with CLP and the lines did not go away, as I thought it was plastic shavings from the stock. Will this cause problems down the line? I'll try to affix a picture. The lines do no look very deep but has the markings on the entire circumference of the RE.
BCM RE.jpg
Thanks for your input. Enjoy your Memorial Day.
Updated with clearer picture.
BCM RE 2.jpg
****UPDATE****
After several e-mails back and forth of me asking questions, BCM sent me a shipping label (2 day UPS) to have the lower inspected. The lower was at BCM for approximately one day, and they had fixed the issue.
I sent an e-mail and inquired what had been done. BCM stated that the original RE was in spec but they had switched it out for another. I also had a Troy sling mount attached to the RE which the allen bolt was rounded. They removed it. They also installed their QD endplate for me.
Basically BCM went above and beyond to put my mind at ease. I can't thank them enough.
Bookmarks