The gun needs it badly and there a lot of them out there.
The front sight is fine but the rear sight stinks. If it's up close to your face it's worthless. (Blurred because it's so close to your eye)
There is a airsoft (printed plastic) rail that mounts in place of the rear sight. Maybe a metal / quality poly rail would stay if it were epoxied in place? Even better would be driving out the pin that holds the rear sight insert, having a rail that utilizes that same pin, plus epoxy.
Or, a unit that mounts over the top and sides of the upper could be held on using set screws into the sides. This would interfere with the original style stock if applicable.
Or, a unit that mounts to the front of the upper just behind the barrel. It would be a clamp-on device. This would also interfere with an original style stock.
Or, the Ar-style buffer tube style adapter (that already exists) could be redesigned to include a rail on the top with the proper orientation for the RDS. I saw this was done but it looked like a one-off.
There are ways of doing this and I want it!
Bookmarks