Well it's here! Took me a few days to get time to take some pics. I can't say how excited I am get get this back and just check it out. Beyond happy with everything.
Tons of work went into this and you can tell when you're holding it.
I need to get a lighter toned 40 round bakelite mag to pair with it.

Everyone at the gun shop was geeked to check it out. They couldn't believe I hadn't even see it yet and they they'd all seen it before me. The whole place gathered 'round to watch the unboxing. Haha.

I can't wait to get to the range.


7six2 by Damage Photos, on Flickr


FDS_8546 by Damage Photos, on Flickr


FDS_8539 by Damage Photos, on Flickr


FDS_8536 by Damage Photos, on Flickr


FDS_8535 by Damage Photos, on Flickr


FDS_8540 by Damage Photos, on Flickr


FDS_8541 by Damage Photos, on Flickr


FDS_8542 by Damage Photos, on Flickr


FDS_8537 by Damage Photos, on Flickr


FDS_8547 by Damage Photos, on Flickr


FDS_8538 by Damage Photos, on Flickr



From "tip to tail" here are some details from KM3:
Jmac RRD4c Keymo

Jmac 14.5" Barrel

Jmac Gas Block

Romy G Kit

Childers Receiver - engraved and all Cerakoted OD/Bazooka green

RS Regulate rail - machine turned flats, ghosted Elite Cerakote and Burnt Bronze

VEPR heat shield - Cerakote gold mix

Gas Tube - Cerakote bazooka green

MAK90 top handguard with Khyber customs Swiss grater inset, cerakote burnt bronze, wood refinished and cerakote cleared

Bolt carrier - engraved and cerakoted custom gold mix

Bolt - polished, deburred, cerakote Elite Smoke

Sabrewerks sight system with SHIELD sight.

JMac Stock Adapter Cerakote Burnt bronze

Khyber customs VERA grip - bottom custom cut, stippled, refinished, Cerakote cleared

Romy G dong, cut and modifed into MLok shark fin, refinished and Cerakote cleared

Jmac Prototype stock, machine turned and ghosted in cerakote elite/burnt bronze, drilled and tapped for riser

Cheek riser - top of MAK-90 stock, fitted and refinished, Cerakote clear

CMC trigger, coated in custom gold Cerakote mix

Krebs safety lever