I settled for a Gen 5 G19 MOS because I didn't want to wait for the possibility of a non-optics version.. It's by far my most favorite Glock. Might have to pick up the FS model too.
I settled for a Gen 5 G19 MOS because I didn't want to wait for the possibility of a non-optics version.. It's by far my most favorite Glock. Might have to pick up the FS model too.
Last edited by R.O.U.S.; 08-10-19 at 00:40.
Not going to get rid of my standard Gen 5 19 for this, but this is how it should have been out of the gate.
This is what the Gen 3 should have been.
I’ll wait until they make this exact configuration but with a factory tan frame, then I’ll bite
I checked one out yesterday, really liked it, QC was great, I don’t own an MOS version yet, so I was trying to make up my mind which one I should get, when a transformer blew outside and out went the lights and computers!
They open again on Tuesday... Thinking I might go MOS first, then the FS.
I picked up a LNIB take off G19 Gen 5 MOS frame and mated it to my ATEI worked over G19 Gen 5 slide. Sold the G19 cut out frame.
Serial numbers don't match but I don't mind.
POW-MIA, #22untilnone
Let Us #NeverForget!
If I agreed with you, we'd both be wrong.
The last thing I want to do is hurt you,
but it's still on my list.
I want one of these as well as a gen 5 g26 fs
Sent from my iPhone using Tapatalk
I ordered two of these today with the Ameriglo night sights. With Glock’s somewhat slick DLC finish, the FS serrations make it *much* easier to do a press check if one desires to. Glock also does a good job of deburring the serrations where they aren’t so sharp but still have enough bite to them. I like them. I should have mine by this Wednesday.
Last edited by Biggy; 08-15-19 at 21:21.
Not to hijack, but will a gen5 fit into a safariland thumb break owb holster that was made for a gen4? I know the gen5s are wider now with the ambi slide stop
Bookmarks