Glock MOS sight height lower 1/3 co-witness

[RWH24]

I don't want the rear sight up in the middle of my view. Prefer to be lower 1/3 like my M&P's are with rear sight in front of the RMR.

This a first for me, rear sight then RMR, don't want to confuse myself. I will use Ameriglo black on black sights.

Thanks

[TheTick]

I'm in the same boat: trying to find the correct information and buy once and then pass the correct information onto my guys.

I do know that it depends on which plate you're using as different companies have different thickness of their plates.

For me specifically, I'm going to be using a CHPWS plate and have been searching for the straight dope on what height Ameriglo blacked-out sights (or model) give me 1/3 co-witness.

Following...

[SteveL]

I'm setting up a gen 5 G19 MOS with Holosun 507C and plate from CHPWS and have been looking for this information as well. Someone on TOS said they were using the Ameriglo GL-429 sights so that's what I'm trying out. Unfortunately UPS could not be bothered to deliver my optic yesterday so I couldn't get it all put together yet. Hopefully Monday I'll be able to tell you for sure if this combination works out.

[RWH24]

I too have the CHPv3 plate on my MOS slide. I used the Trijicon MOS HD/XR sights at first, but I found the deal on an RMR.
The distance from the slide to top of RMR at rear is .250" ish. About the same height as the HD/XR MOS rear sight, actually .231".

Looking at Ameriglo single sights, Frt black and Rear black, A .315/.330/.350 front??
Rear .360/.394??



A .394" rear will pace the top of the sight well above the back of the RMR with the C&H plate. The bottom of the notch will be ?? IDK

I'm not machinist precise with a caliper. Close counts like Horseshoes and hand grenades.

[mfbpt]

Check out 10-8 performance. I put a set of their mos sights on my 34 and their right at the bottom of the rmr. Ended up with a .315 front for a perfect match.

[z71lover8]

Check out 10-8 performance. I put a set of their mos sights on my 34 and their right at the bottom of the rmr. Ended up with a .315 front for a perfect match.

Was this on a mos or milled?


Sent from my iPhone using Tapatalk

[jpmuscle]

https://dawsonprecision.com/dawson-p...ed-dot-scopes/

Call and ask if you want 1/3


Sent from my iPhone using Tapatalk

[RWH24]

https://dawsonprecision.com/dawson-p...ed-dot-scopes/

Call and ask if you want 1/3


Sent from my iPhone using Tapatalk

That has a very narrow notch, .125. IIRC Ameriglo is .150 and frt sight is .090 wide
Thanks for the info

[RMiller]

[RWH24]

I think I am going to sell my G45/19 MOS and pay to have my other G45 milled for an RMR. Get #dougified at #ateiguns

Use the shorter Ameriglo Black on Black .315 frt and .394 rear. AND GET the rear sight dovetail cut in front of the RMR like my M&P9 1.0