Best standard safety selector

[WS6]

This will probably seem trivial to most. But I have a few builds in which I used Aero and other generic lower parts kits for and the safety selectors are not positive at all. I tried a Geissele posi snap safety but it was entirely too stiff.

Are there particular safety selectors you choose over others?

Hands down Badger Ordnance. It is the smoothest and crispest I've used, without being super stiff or any weirdness. It's just a very high quality 4140 bar stock phosphate selector. The C1 variant is ambi.

[m4luvr]

as a bonus the badger ordnance is conveniently marked on the opposite side so it can be seen or felt

[jackblack73]

I have a bunch of extra detents and springs. I mix and match until I get the feel I like. Because of the variation of the holes in grips and manufacturing tolerances of the springs, detents, and the safeties, you’re going to get varying degrees of resistance.