Does anyone have a picture of where the gas tube would meet the gas key? I had to replace my tube and it's short stroking now and I'm concerned the tube it too short. It short strokes work. 223 loads but runs fine with 5.56.
Does anyone have a picture of where the gas tube would meet the gas key? I had to replace my tube and it's short stroking now and I'm concerned the tube it too short. It short strokes work. 223 loads but runs fine with 5.56.
Should be in the center of the circular cut out in the upper receiver.
Here you go.
Black River Tactical
BRT OPTIMUM Hammer Forged Chrome Lined Barrels - 11.5", 12.5", 14.5", 16"
BRT EZTUNE Preset Gas Tubes - PISTOL, CAR, MID, RIFLE
BRT Bolt Carrier Groups M4A1, M16 CHROME
BRT Covert Comps 5.56, 6X, 7.62
Dang thanks looks like it's long enough, not sure why it's short stroking now.
Why did you need to replace the gas tube?
Did you pull the gas block when you replaced it?
Where did you get the gas tube?
Who make the upper?
I replaced it because my previous gas tube broke off into my gas block. I replaced the whole block also as it had the tip of the tube in it. I got the gas tube and block off of midway or primary arms cheap block and tube. And the upper is a gun show special kind of thing with no manufacturer markings.
Gentlemen I have an issue I got a 7 inch tube to replace what looked to be another tube that was a hair too short it appears I've come up short again I replaced the random block with an Odin arms one also. I'm not sure what my issue is pics will be incoming shortly
How do I post pictures in here?
Last edited by Yimmy; 11-06-19 at 20:06. Reason: I needed to add a photo
I have no experience with sub-carbine length gas systems, but that certainly won't work. What's the barrel?
Bookmarks