Just as the title says. I’m looking to replace my factory scar gas jet with a Parker mountain one so I can run a can without destroying my bolt and carrier. What size are you guys going with? I’m leaning towards 1.7 or 1.8mm
|
||||||||||||||||||||||||||||||||||||||
Senior Member
Just as the title says. I’m looking to replace my factory scar gas jet with a Parker mountain one so I can run a can without destroying my bolt and carrier. What size are you guys going with? I’m leaning towards 1.7 or 1.8mm
I paint spaceship parts.
Originally Posted by Failure2Stop
Site Sponsor
Did you order the factory 10"? Doesn't it come with a gas jet?
What did Parker Mountain suggest?
I didn't think the jets were very expensive. I'd start with the smaller one, and go larger if I ran into cycling problems. Or just buy both.
The reason I cannot give you a direct answer is because I haven't done the SBR yet because I haven't moved out of Commiefornia yet. So all my SCARs are in limbo.
You might want to have both in case you put a can on and determine the switch doesn't cut off enough gas.
Also, check the FN forum.
Last edited by ScottsBad; 04-28-20 at 22:08.
Posting Permissions
Reply With Quote
Bookmarks