Just as the title says. I’m looking to replace my factory scar gas jet with a Parker mountain one so I can run a can without destroying my bolt and carrier. What size are you guys going with? I’m leaning towards 1.7 or 1.8mm
Just as the title says. I’m looking to replace my factory scar gas jet with a Parker mountain one so I can run a can without destroying my bolt and carrier. What size are you guys going with? I’m leaning towards 1.7 or 1.8mm
Did you order the factory 10"? Doesn't it come with a gas jet?
What did Parker Mountain suggest?
I didn't think the jets were very expensive. I'd start with the smaller one, and go larger if I ran into cycling problems. Or just buy both.
The reason I cannot give you a direct answer is because I haven't done the SBR yet because I haven't moved out of Commiefornia yet. So all my SCARs are in limbo.
You might want to have both in case you put a can on and determine the switch doesn't cut off enough gas.
Also, check the FN forum.
Last edited by ScottsBad; 04-28-20 at 22:08.
Bookmarks