Model 1761. 3 inch .44 special.
I don't care for the factory rear or front "Hi-Viz" green.
It seems "normal" aftermarket Gp100 sights don't fit this model and a few others for some reason.
Anyone know of an aftermarket choice for this model?
Model 1761. 3 inch .44 special.
I don't care for the factory rear or front "Hi-Viz" green.
It seems "normal" aftermarket Gp100 sights don't fit this model and a few others for some reason.
Anyone know of an aftermarket choice for this model?
The GP series used to allow easily swapped front sights; using a plunger in the end of the barrel. Changed in under 2 minutes. Current generation models don't seem to have it.
If a traditional constructed front sight is your goal, a Redhawk sight might fit.
You might contact Novak about the front sight and Bowen about the rear sights.
Thanks.
Something about the factory Hi-Viz-equipped Gp100's means they cannot use standard Gp100 front sights or aftermarket replacements.
I'm not sure what.
If Rugar only made a GP 100 in a .41 mag...
10 mm close enough? Because they do make that.
https://ruger.com/products/gp100Matc...eets/1775.html
https://ruger.com/products/gp100/specSheets/1780.html
I'm digging this one! Have zero use for it, sadly.
https://ruger.com/products/gp100/specSheets/1769.html
Last edited by Ron3; 12-30-19 at 23:45.
Ron,
10mm is close, but Ruger also has .41 in the Redhawk and it’s can be had in a “mountain gun” configuration. I like to stay in the 4”-6” lengths...
A true "Gun Guy" (or gal) should have familiarity and a modicum of proficiency with most all firearms platforms.
Bookmarks