This has been a question several times, Milled or MOS for RMR

[dan1612]

CHPWS plate on MOS works just fine and fits in Safariland level 3’s.

[Sooter76]

Sure it does. Not all aftermarket pre-cut slides fit holsters made for factory guns. Nothing to do with the RMR cut itself.

Then they won’t fit an MOS slide either… So your point is moot.

[1168]

Then they won’t fit an MOS slide either… So your point is moot.

I don’t seem to be explaining this adequately. There was at least one aftermarket slide that did not fit properly in holsters, even without an optic. The edges were not radiused or chamfered or whatever, and that caused issues. That company has since updated their slides, but the point I made like a year and a half ago, that you quoted, is completely accurate.

[Business_Casual]

I don’t seem to be explaining this adequately. There was at least one aftermarket slide that did not fit properly in holsters, even without an optic. The edges were not radiused or chamfered or whatever, and that caused issues. That company has since updated their slides, but the point I made like a year and a half ago, that you quoted, is completely accurate.

Yeah I have a Suarez slide that balks at some holsters and a Lone Wolf that is beveled. I also have MOS which I feel is best because it future proofs your set up far more than milling. YMMV.