I have an Aero PDQ lower (with the PDQ & spring, pin) already installed from the factory. The issue is on the right side the end of the roll (split pin) is flush, but on the other (left side) the end doesn’t go all the way out flush, there are a few millimeters of space. I’m concerned that with it being that uneven & not centered it could potentially break off during hard use. Is this normal? Please let me know what you guys think & what you think I should do. I’ve attached a few photos. Thanks.
121566B9-2077-4D75-8181-DF9B2F699289.jpeg
3A6A62FF-38DC-4A6F-95F8-731429143D84.jpeg
Bookmarks