With these handguards, specifically with a carbon fiber 308 Troy M-LOK handguard, does this “snap” place when rotating back to center with the upper receiver?
Per (terrible) instructions, I slide on while rotated about 5 degrees to the left:
If I rotate beyond the center line, it seems to “snap” into a solid position, but rotated slightly right.
I can center it just fine and tighten screws. However, I ask, because it feels like a very positive “set”/“snap” when I rotate it to the right as shown in the second picture above. If that’s normal to feel when out of position (but feels right, if that makes sense), I’ll just center and set the screws. Just wanted to check.
Bookmarks