|
||||||||||||||||||||||||||||||||||||||
Member
Hello,
I built a DD 10.3 with A5 system. I bought a sprinco green and my setup does not cycle with any buffer. I tried everything from A5H0 to and H3 and nothing. It’s 556 loads. I am going to get a regular rifle spring but this is a frustrating moment for me. At DD they did explain that they use a regular carbine spring with a carbine H1 buffer.
This was after the fact that I had built what I explained above... this is the first time I have an issue with the A5. I need some help.
Last edited by elpotro; 07-10-20 at 20:28. Reason: Typo
Senior Member
Sounds like something isn’t right.
Try a carbine spring to see what happens.
A MK18 should run fine on a carbine spring and H thru H3 buffer.
Member
I’m not supposed to put a carbine spring on an A5 buffer tube correct?Originally Posted by 17K
Site Sponsor
Correct, CAR spring and buffer requires the 3/4" shorter CAR tube.
<><><><><><><><><><><><><><><><><><><><><><><><>YOU IDIOTS! I WROTE 1984 AS A WARNING, NOT A HOW-TO MANUAL!--Orwell's ghost
Psalms 109:8, 43:1
LIFE MEMBER - NRA & SAF; FPC MEMBER Not employed or sponsored by any manufacturer, distributor or retailer.
Senior Member
Try a different bolt if you have one, built up a 11.5 once with all new parts that didn't want to run and swapped a BCG from another upper with a couple of hundred rounds on it and both have been 100% since then, go figure.
“The Trump Doctrine is ‘We’re America, Bitch.’ That’s the Trump Doctrine.”
"He is free to evade reality, he is free to unfocus his mind and stumble blindly down any road he pleases, but not free to avoid the abyss he refuses to see."
Senior Member
It's clearly NOT an A5 buffer issue. Does it seem OVER or UNDER powered?
"What would a $2,000 Geissele Super Duty do that a $500 PSA door buster on Black Friday couldn't do?" - Stopsign32v
Senior Member
Is there any gas block misalignment?
Sent from my iPhone using Tapatalk
Member
I will check that right now. It would be the first time ever that I misaligned a gas block but there is always a first time. I do have a Ballistic Advantage gas block on a Daniel Defense barrel. That is the first time I ever did this. I built this with spare parts except the Barrel that I did buy. The BCG is a BCM.
Senior Member
So is it dual dimpled or just a single?
Member
It is dual dimpled... I will go out and test on another lower and I ll get a regular Rifle Spring. I hope is not the BCM BCG. I had a bad experience with a BCM BCG once but I attributed to bad luck... but now I am wondering. I have other BCG for spare... I will keep you all posted. Thank you for your help.
Posting Permissions
Reply With Quote
Bookmarks