Originally Posted by
dewshe
So I got everything broken down, and realized that I made a mistake during assembly. When I was punching in the pin, I didn't tighten the set screw enough, and the block twisted on the barrel, causing the block to be canted.
I reassembled, and now everything lines up as it should. I didn't realize the pin could be driven in with the block out of alignment, but it can.
I still feel the response from customer service was lacking, and I have yet to hear back from Mason regarding the technicals on gas block tolerances.
Regardless, apologies for rustling feathers, if I did so.
Bookmarks