Parts list:
Upper: $650 shipped OBO, NOW $550 SHIPPED OBO
WMD NiB-X receiver
BCM BCG
BCM KMR-A10 (cut down to 9 5/16”)
BCM Keymod rail panels
BCM Mod 3 “vertical” grip (not 90° vertical) - if this scares you I’ll remove it
Ballistic Advantage 10.5” government profile modern series barrel with carbine gas system
Ballistic Advantage melonite gas tube
Ballistic Advantage lo pro gas block
Radian Raptor CH (was bought used so it shows more wear than the rest of the stuff)
Strike Industries ultimate dust cover
I removed my QD suppressor adapter muzzle device and have loosely screwed an A2 FH on to protect the threads. There’s no crush washer on it so you’d need to take care of that before shooting it.
Lower: SOLD
Battle Arms Development BAD-15 receiver
Battle Arms Development BAD-CASS short throw ambi safety
Battle Arms Development EPS pivot and takedown pins
Battle Arms Development BAD-EMR enhanced mag release kit
BCM PNT trigger
BCM QD end plate
Magpul polymer trigger guard
Hogue 15020 beavertail grip
SB Tactical SBA3 brace
Wise Men Company SplitFix strap on the SBA3
The rest of the lower parts kit (bolt release, springs, etc.) are from a CMMG LPK.
The upper has some marks on it from where my red dot and magnifier were mounted. Also a small mark on the trigger guard roll pin hole. I built this gun myself. It’s been to the range once and has just been sitting in the safe since. I’ve decided to thin the herd a little to free up some cash for some other interests. Not looking for any trades.
Priced as follows, OBO:
FTF around Frankfort or Lexington, KY - $1,050
Shipped from me to your FFL - $1,100
Shipped from my FFL to your FFL - $1,150
Payment by Zelle, Venmo’s PayPal (gift or you cover the fees).
Reply With Quote
Bookmarks