I’m attempting my first build and when putting the buffer tube on I noticed after the staking that it might be a mm or two at most off center to the left. My stock is on the way so can’t really see if it’s negligible or not. It’s a Vltor a5 RE with HSP end plate. If I need to rebuy the end plate I will as I don’t think there’s a way to salvage it at this point if I needed to remove the castle nut and realign. So, my question is if it is off a mm or two to one side is it good to go still or should I just take it off and start again?
If I have to start over anyone got any recommendations for a gunsmith in NW GA that won’t try to bubba the build like someone already did earlier on in the build when I started?
I searched for the exact questions and couldn’t find anything quite what I was looking for so I’m hoping this may help someone in the future as well. Thanks again everyone.
Bookmarks