RCBS can sell you spacers of the correct thickness so you can set up your dies for .38 spl and .44 spl, and then just use the spacer for .357 mag and .44 mag. The spacer is the same thickness as the difference in case length. You use these on all dies except the sizing die.
But they don't make a similar one for .40 / 10mm. I emailed RCBS and got no response.
I found a guy on ebay that does. For less than $20 you get three spacers. I measured mine and they're 0.142", which is what they need to be.
This saves reloaders from either buying a new set of dies (minus sizing die) or re-adjusting every time.
See mex1910 on ebay.
NOTE: I'm not advertising for this and didn't get anything free. If this violates a rule mods please delete. I'm just passing it along to help other loaders.
Bookmarks