Are these reloads? Or in spec factory rounds?
Could be out of spec chsmber. But before we rule that the culprit you need to clean the snot out of the chamber. The factory packing grease could still be caked on the chamber walls. Think of it as if you are removing dried on glue. Get a chamber brush or bore brush that fits snug in the chamber and a single section of a three piece cleaning rod. Use a drill to spin the rod and brush inside the chamber for a few seconds. Then clean the chamber and barrel all over again. See if a round will go into and come out of battery easily. Repeat if it got better but not perfect yet. Last resort would be to lap-polish it with some 2000 grit sand paper wrapped around a SG cleaning rod. You may want to contact PSA before doing that though and see how to go about replacing for a different one.
Twenty years from now you will be more disappointed by the things you didnt do than by the ones you did do. So throw off the bowlines, sail away from the safe harbor. Catch the trade winds in your sails. Explore. Dream. Discover.
- Mark Twain
Bookmarks