Mounting Holosun on a P365XL

[63Qcode]

Looking for a little help here . I was going to mount my Holosun 507 on my P365XL last night and ran into a small problem . I can`t get the stupid set screws inside the slide loose . I was using a 2mm Allen wrench per Sig and it started to bend and I was afraid if I put more pressure on it , it would strip the internal socket out .

Suggestions welcome . I thought about heat , but really don`t want to put a propane torch on it , maybe a heat gun ?

Thanks

[Goatdog]

I used a heat gun. Easily broke loose after about 20 seconds of heating

Sent from my SM-N960U using Tapatalk

[georgeib]

I used a heat gun. Easily broke loose after about 20 seconds of heating

Sent from my SM-N960U using Tapatalk

This, or pressing the tip of a soldering iron to the head of the screws for 30 seconds should do the trick