Originally Posted by
lysander
Not if you want an accurate measurement.
Bore micrometer:
Or, if you are less extravagant, telescoping gauges and an outside micrometer:
Oh, and the clamping force is nowhere near 10,000 pound as someone stated in that thread.
With properly greased threads the clamping load is 1,800 pounds to 4,800 pounds.
Mil-spec barrel nut torque is 30-80 ft lbs. So 1,800 lbs of clamping force is on the lower torque end (30 in lbs) and 4,800 lbs would be on the 80 in lbs side?
You won't outvote the corruption.
Sic Semper Tyrannis
Bookmarks