Results 1 to 6 of 6

Thread: Buffer and spring recommendations for 300 blackout

  1. #1
    Join Date
    Apr 2020
    Posts
    34
    Feedback Score
    0

    Buffer and spring recommendations for 300 blackout

    The info I have come across seems conflicted; No H2 or H3 buffer vs H2 buffer is standard.
    Any insight is appreciated.

  2. #2
    Join Date
    Feb 2013
    Posts
    1,732
    Feedback Score
    49 (100%)
    I have an AAC factory-built 9" upper and they recommend an H2 buffer.

    Straight from their website: "ACTION SPRING/BUFFER
    Use either the standard USGI M4 or the HK 416 spring. For buffers, select a 4.6 oz (130 gm) H2 or an HK-416 bufferthough a 5.5 oz (155 gm) H3 buffer may be a good choice if you donít intend to shoot subsonic without a sound
    suppressor or typically shoot supersonic ammo. Do not use a solid 9mm buffer as it may cause bolt bounce."

    But it also depends on what you plan on shooting. Supersonic vs subsonic vs subsonic suppressed may all cycle better with different buffers in your particular gun. Gas port size will also be a factor.
    Last edited by officerX; 05-30-21 at 22:00.

  3. #3
    Join Date
    Apr 2020
    Posts
    34
    Feedback Score
    0
    Thank you officerX !!
    Mainly shoot sub suppressed with 10.3 barrel.

  4. #4
    Join Date
    Dec 2009
    Location
    New Mexico
    Posts
    936
    Feedback Score
    4 (100%)
    LARB MOD2 buffer SprinCo white spring
    FFL/SOT

    Chuck Norris has to maintain a concealed weapon license in all 50 states in order to legally wear pants.

  5. #5
    Join Date
    Aug 2016
    Location
    Alabama
    Posts
    597
    Feedback Score
    1 (100%)
    Like most of my other carbines and pistols (5.56), I did a basic carbine spring and H3 on my 9". No issues and a nice shooter.

  6. #6
    Join Date
    Feb 2012
    Location
    Upstate, SC
    Posts
    678
    Feedback Score
    14 (100%)
    My Ballistic Advantage 8.3" Hanson barrel requires a heavier set up than their recommendation. I believe the port was drilled too big. I was using an H3 with a carbine spring. I believe they recommended an H1 when I reached out to them, but it's been a few years since then. I recently installed a BRT gas tube and switched to an A5 buffer tube and A5H2 buffer. This has helped tremendously.

  7. #7
    Join Date
    May 2013
    Location
    AZ
    Posts
    39
    Feedback Score
    0
    There isn't a single answer IMO. How is your rifle configured? Barrel length, gas system (pistol, mid, rifle length), intended bullet use (super, subs, both), suppressed? All will have an effect on cycling reliability. For instance, I have a 9.5" pistol gas that runs strictly sub/suppressed with a carbine spring/buffer. runs EVERYTHING that's subsonic 100%. Change it's mission and it might not be 100%. Balance it out to run sub/super and at the fringes may be iffy. JMHO YMMV

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •