ETA on when these might show back up? Looking to swap out stock on my MCX.
ETA on when these might show back up? Looking to swap out stock on my MCX.
Love you Pop. F*ck Cancer.
We will begin machining the next run of them on a few weeks. I would say 6-8 weeks.
thank you for your interest.
Troy
MI
Question: Is there any way the STAP-SF can be retrofitted with a thumbscrew or lever release to replace the screw assembly, something like https://www.admmfg.com/std-lever or the thumbscrews on some optic mounts? I'm penciling out a "quick-change" backend kit as part of a Ruger Charger "convertible" project I'm considering, and needing an Allen wrench is one of the sticky parts on the concept. (Yes, I could use the same tube in both braced pistol and stocked rifle setups and just swap 'em on the same tube like an AR, but then I have to fight with installing/removing length of pull limiters and that kinda negates the "Quick Change Kit" concept.)
<><><><><><><><><><><><><><><><><><><><><><><><>YOU IDIOTS! I WROTE 1984 AS A WARNING, NOT A HOW-TO MANUAL!--Orwell's ghost
Psalms 109:8, 43:1
LIFE MEMBER - NRA & SAF; FPC MEMBER Not employed or sponsored by any manufacturer, distributor or retailer.
Thanks, Troy. It's admittedly a bit of an "Out In Left Field" situation, most customers are probably more "mount it once and done."
<><><><><><><><><><><><><><><><><><><><><><><><>YOU IDIOTS! I WROTE 1984 AS A WARNING, NOT A HOW-TO MANUAL!--Orwell's ghost
Psalms 109:8, 43:1
LIFE MEMBER - NRA & SAF; FPC MEMBER Not employed or sponsored by any manufacturer, distributor or retailer.
We have internally discussed situations where someone may want to install or remove it in a faster way. I have a design in the works already . We would sell a different type of cross bolt that could be purchased separately.
Troy
MI
Bookmarks