Tips for 200yrd spinner

[1986s4]

Other than making sure my 50/200 zero is spot on at 200 what other tips do you have for this challenge? I've watched youtube vids on spinners, I've never shot at one. I'm using a 5.56 with 14.5" barrel and Federal XM193F 55 grain ammo.

Thanks

[Matt in TN]

Rifle spinners are tough at 100 yds, much less 200. Using 55gr ammo makes it even harder still.

Remember there will be a time lag between when you pull the trigger and when the bullet hits the target. Pull the trigger right when the spinner changes directions and just STARTS to swing backwards - don't wait until halfway through the swing or it will hit too late.

And bring plenty of ammo. Good luck!

[1986s4]

Rifle spinners are tough at 100 yds, much less 200. Using 55gr ammo makes it even harder still.

Remember there will be a time lag between when you pull the trigger and when the bullet hits the target. Pull the trigger right when the spinner changes directions and just STARTS to swing backwards - don't wait until halfway through the swing or it will hit too late.

And bring plenty of ammo. Good luck!

Thanks man ! I just got back from assuring my 200yd zero on a 8" steel plate. It went well as long as I do my part...... This will be challenging.

[Matt in TN]

Let us know how it goes!

[1986s4]

Let us know how it goes!

It won't be for another month but will do. I was using a 2 moa aimpoint RD with 3x magnifier. Now upgraded to a 4x magnifier. Now back to the 200m/220yd range with some 8" plates for practice which will have to do since a spinner is not available.

[B Cart]

I've shot many spinners in PRS matches, but always with precision bolt guns. Making hits with a precision bolt gun is much easier, as most precision rifles are shooting 1" groups at 200 yards. The trick is timing the shot based on the spin of the spinner plates, so I generally shoot as the largest bottom spinner plate is coming down, NOT when the plate is already at the bottom. Your shot time delay will depend on distance to target, and how fast the spinner is spinning, and with some practice, you will start to see when you need to brake your shot. Also, it's generally better to shoot the bigger bottom target, as it's heaver with more momentum, and you will usually get the spinner all the way around quicker.

I would assume 200 yards with a 14.5" AR with M193 would be tough, as most ARs are shooting 2-4 MOA with M193 ammo, vs .5 MOA with a precision gun. Also, a 55 gr .223 bullet is not going to move the spinner like a bigger 6mm, 6.5, or .30 cal bullet will, so it may take more hits. That being said, it's probably very possible to do with an AR, but will take some actual practice on a spinner. Hope that helps a little

[1168]

Good luck, let us know how it goes.