From one quality tool enthusiast to another, thank you and back at ya!
And it's not that I haven't installed grip screws without a torque screwdriver, I certainly have, but I like to get them to 35 inch pounds. There's been a few times that I thought I did a good enough job just by feel alone, but when I double checked with the torque screwdriver they were slightly below that magical number. Apparently my feel isn't perfect, and I bet most people's estimations are off... I use the torque screwdrivers on buttstock screws too.
I actually bought the Gedore torque screwdriver because it goes up past 40 inch pounds. That's the max range of the CDI and they don't make one that goes higher unfortunately.
The Snap-On torque wrenches are awesome too. The bigger (Ft-Lb) one has a scale from 5 to 75 foot pounds and the smaller (In-Lb) one goes from 40 to 200. And I prefer the fixed heads instead of the ratcheting heads for use with all the extended AR wrench adaptors. It just keeps things in line so I don't have the tool spinning around constantly (minor annoyance, but it bugs me). I'd probably get ratcheting heads if I wanted to work on cars, but for ARs I just prefer fixed.
Last edited by 556Cliff; 07-20-22 at 22:49.
I agree about the OP, he just needs a decent quality screwdriver bit set and it shouldn't be a problem finding a bit to fit most screws. Though you can certainly get carried away with things like this depending on your level of OCD, I know I sure have.
Originally I was only OCD with ARs, but through working on them and putting them together I became just as OCD about the assembly tools.
I know that there are a lot of people that are happy to put an AR together using only a spoon, a couple of toothpicks and a butt vise at their kitchen table, but I just can't fathom that approach.
Bookmarks