Does the dimpling jig have a witness hole for the gas port? Or how do you align TDC so easily?
Thanks.
It has a pointed set screw that engages the gas port, and another nylon tipped set screw that tightens against the barrel to hold the jig in alignment so that you can drill the dimples.
It has a pointed set screw that engages the gas port, and another nylon tipped set screw that tightens against the barrel to hold the jig in alignment so that you can drill the dimples.
I assume you are looking for a jig. All I can tell you is that Bravo has them but they have not been put on their website yet. Maybe a e-mail to Paul would help you out.
I assume you are looking for a jig. All I can tell you is that Bravo has them but they have not been put on their website yet. Maybe a e-mail to Paul would help you out.
Thanks
Paul is going to sell your front sight base (no the low profile GB drilling jig) jig?
Thanks comp, I forgot to ask. Are these setup for F-height FSB only or can they be used with the non-F-height FSBs too?
They are set up with a little clearance for F height. I would think that it would work for the A2 as well but may have a small gap between the key stock and FSB.
They are set up with a little clearance for F height. I would think that it would work for the A2 as well but may have a small gap between the key stock and FSB.
Thanks. Maybe I could add a small shim to close the gap.
Bookmarks