swapped rails on my 10.5" SBR

[Leonc]

Oh my my ...
Your rifle set-up is out of this world.
Would the suppressor clear with a 9.5 lite set-up as well?
Or must you use this rail set-up for clearance?
I would imagine either one would work if need be. Correct?
Was your barrel cut down exactly to 10.5" not any longer?

Hence my asking is, I'm looking to purchase an Addax 10.5" Gas Piston upper -
Their upper comes with a Daniel Lite 9.5" Rail -

Just want to make sure it's going to clear the suppressor -

Also that's an M4-2000 suppressor, correct?

Did you have to make any modifications for this set-up to work?

From your experience -
Would you take an educated guess that this set-up with work with your suppressor?



It's a 10.5" Gas Piston Upper -
With a 9.5" Daniel Lite Rail -

Thank you kindly.

[Robb Jensen]

Oh my my ...
Your rifle set-up is out of this world.
Would the suppressor clear with a 9.5 lite set-up as well?
Or must you use this rail set-up for clearance?
I would imagine either one would work if need be. Correct?
Was your barrel cut down exactly to 10.5" not any longer?

Hence my asking is, I'm looking to purchase an Addax 10.5" Gas Piston upper -
Their upper comes with a Daniel Lite 9.5" Rail -

Just want to make sure it's going to clear the suppressor -

Also that's an M4-2000 suppressor, correct?

Did you have to make any modifications for this set-up to work?

From your experience -
Would you take an educated guess that this set-up with work with your suppressor?



It's a 10.5" Gas Piston Upper -
With a 9.5" Daniel Lite Rail -

Thank you kindly.

I'm fairly certain that a 9.5" FSB Lite Rail won't work with a 10.5" barrel and M4-2000 mod 07/08. My Mk18 rail is shorter than my 9.5" FSB Lite Rail that I have on my Colt. My barrel was cut to exactly 10 7/16". I measure it before mounting my Blackout. I measure from the face of the bolt to the end of the muzzle threads.

[Derek_Connor]

I'm fairly certain that a 9.5" FSB Lite Rail won't work with a 10.5" barrel and M4-2000 mod 07/08. My Mk18 rail is shorter than my 9.5" FSB Lite Rail that I have on my Colt. My barrel was cut to exactly 10 7/16". I measure it before mounting my Blackout. I measure from the face of the bolt to the end of the muzzle threads.

I can verify this with 100% certainty, the 9.5FSB will NOT work with a 10.5bbl setup for an M42000.

I had to cut my 9.5FSB to make it work.

Here is a picture showing the threads being JUST TOO close to the rail:




Here it is after the cut:

[JoshNC]

Here it is after the cut:

Derek, where did you pick up those precision shims for the flash hiders?

[Derek_Connor]

Derek, where did you pick up those precision shims for the flash hiders?

MSTN took that photo to be honest...i'll ask him

[Robb Jensen]

That's pretty sweet Derek.

[openbolt]

What mount is this under the T1, and would you recommend it?

[Robb Jensen]

What mount is this under the T1, and would you recommend it?
http://img.photobucket.com/albums/v4...4/mk18rail.jpg

That's a ADM mount with the SOCOM height spacer (for lower 1/3 co-witness) and yes I highly recommend it.