Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: RRA 2 stage trigger oversized pins didn't fit

  1. #11
    Join Date
    May 2008
    Location
    Arkansas
    Posts
    1,841
    Feedback Score
    16 (100%)
    I've got 2 carbines with the RRA triggers. I didn't use the included pins in either carbine. I hate to ream out something that doesn't need it and is not able to be put back to original condition.

    On another note I did have a new, reputable lower that I was building on and had to use .155 KNS pins to get proper fit. Tolerances are a bitch sometimes.
    "The peace we have within us is most often expressed in how we treat others"

  2. #12
    Join Date
    Dec 2008
    Location
    Oklahoma
    Posts
    104
    Feedback Score
    0
    I recently removed my RRA NM2 trigger from my Bushy lower. I replaced the factory trigger and pins. Now the hammer pin is very loose. I can fairly easily push it out with my finger. Would KNS.155 pin sets be the best fix?

  3. #13
    Join Date
    May 2008
    Location
    Arkansas
    Posts
    1,841
    Feedback Score
    16 (100%)
    The .155 would work since they also are secured but since you already had the .156 pins in there they will go back just fine as long as they will go through the FCG, which they should. I would try the .156 pins with your trigger and hammer. If you can get them in, you are good to go. If not the .155 KNS will fix it.
    "The peace we have within us is most often expressed in how we treat others"

Page 2 of 2 FirstFirst 12

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •