3. homemade stuff is nice![]()
|
||||||||||||||||||||||||||||||||||||||
3. homemade stuff is nice![]()
*** Damn Proud to Be an American Ally ! ***
The Armory:
Colt 6601 - Colt 6731 - Colt 613 - Steyr StG.58 - M1 Carbine - Galil SAR - CZ Scorpion EVO - Franchi PA8 - Glock 17 - Pietta/Colt SAA 1873 - SA 1911A1 Mil Spec - Ruger LCP
spamsammich,
it was never answered. in fact until now, I don't know what cast looks like. or cast marks if there are any. I just assume that forge will be heavier than cast. but again. I have nothing to compare it with.
www.cpra.ph
Cebu Pistol and Rifle Association
Take it down to your PD garage/ fleet maintenance shop, and hit it with a grinder. It takes 30 seconds. Touch it up later on with alumablack, and you are all set. I also did a few with a bandsaw and benchgrinder, but cutting with a regular hacksaw or dremel will work easily as well. Any black spray paint will work, you can spray it in a cup and slap it on with a cotton swab if you don't want to spray the entire unit.
The below one was an aftermarket CH that I did with a saw, and then did a quick cleanup with a bench grinder. Its a simple and quick deal no matter how you do it.
One thing I do is keep the supporting/ clamp bar a little long for greater surface contact.
![]()
Last edited by Stickman; 06-07-09 at 13:04.
Stick
Board policy mandates I state that I shoot for BCM. I have also done work for 200 or so manufacturers within the firearm community. I am prior service, a full time LEO, firearm instructor, armorer, TL, martial arts instructor, and all around good guy.
I also shoot and write for various publications. Let me know if you know cool secrets or have toys worthy of an article...
Flickr Tumblr Facebook Instagram RECOILMAGAZINE OFF GRID RECOIL WEB
There is no reason to pay $100 for an LMT buis, if you have a carry handle laying around.
"IF" i were going to pay money for a fixed BUIS, I would buy a Larue instead.
ΜΟΛΩΝ ΛΑΒΕ
I've been considering this for awhile. Looking at Sticks I am gonna go for it.
Bookmarks