Magpul Lower & UBR pics

[Logic]

Ok. Thank you.

[NickB]

Direct copy and paste from email:

Hey Nick,

Both take the same butt-pad so they are approximately equivalent in any
practical sense.

UBR:
1.680" Max width (Slightly down from receiver ext centerline on butt-plate)
1.847" Max width (Using ACR-type Cheek-piece)

CTR:
1.703" Max width (Slightly down from receiver ext centerline on butt-plate)

Eric

[Logic]

Very nice. Without the cheek-piece, the UBR is even slightly slimmer.

[twl]

How much lighter weight is this UBR, than the CTR ?

[NickB]

How much lighter weight is this UBR, than the CTR ?

UBR is approx. 1.25 pounds, CTR is about .785 pounds.

[Impact]

very very nice....that UBR is gonna be a hit for sure..even more than the PSS and CTR I think...

[DrDrake]

Is it impossible to remove the bolt-catch pin?

I'm sure you read this somewhere else already Zak but the bolt catch pin is held in by a set screw. The hole has been tapped and makes for easy remove/install. The rear detent pin spring hole is also tapped. Just cut the spring down, install the takedown pin, install the take down detent pin, install the take down detent spring, install our new set screw and bada bing, no more spring flying to the depths of where ever. Why noone did this before, I don't know. Makes things pretty easy though.

[Mike91A]

I think someone already asked . If ( when) I buy a lower and UBR in the FDE will I be able to get info/paint to match my upper to the lowers color?

[DrDrake]

We have not nailed down what we are going to do with the coating of the lowers. When we do I'll pass it on here. I'm sure we will make it public what colors we're using so you can match it up.

I think someone already asked . If ( when) I buy a lower and UBR in the FDE will I be able to get info/paint to match my upper to the lowers color?

[Crash]

Any update on an expected release date for the Magpul Lower Receiver?

Thanks