Precision AR Uppers

[AR15barrels]

Well the central VA shop I had remove the Gemtech FS'r bent the threaded end of the barrel, then tried to claim it was already bent (which is BS since it worked fine in over 600 rounds through the Gemtech).

Actually, the barrel was NOT bent, but the threads were WAY crooked because they tried to use a die to clean up the boogered up threads.

I put the barrel up in the lathe and spun it and the run-out was obvious.
Looking down the bore, it was straight.

[Robb Jensen]

Actually, the barrel was NOT bent, but the threads were WAY crooked because they tried to use a die to clean up the boogered up threads.

I put the barrel up in the lathe and spun it and the run-out was obvious.
Looking down the bore, it was straight.

I misunderstood you then. It did come out very nicely!