|
||||||||||||||||||||||||||||||||||||||
OP and I are in the same boat.
Im about 90% set on the BCM middy from G&R. looks like a solid buy with quality throughout
Tu ne cede malis
http://mises.org
"Cheer up Jim. Thank God we don’t get as much government as we pay for!"
-Charles Kettering
Caliber: .223⁄5.56mm NATO Chamber Upper Receiver: Forged A4 Probably a .223 chamber. I have yet to see a RRA with a true 5.56 chamber.
Barrel: 16″ Chrome Lined, 1:9 Twist Inferior twist rate that has been discussed here to the point of making people cry.
Muzzle Device: A2 Flash Hider / 1⁄2−28 Thread
Trigger: Two Stage match Not recommended for a fighting gun.
Handguard: Mid-Length Handguard Pistol Grip
Buttstock: A2 Grip / A2 Buttstock
Weight/Length: 7.1 pounds/35.25 inches
Accuracy: 1 MOA at 100 yards So are most rifles with quality ammo.
Also a BCG that is NOT HPT/MPI inspected.
BCM rifle comes with Troy/BCM rear sight. RRA has no rear sight.
RRA rifles and their inferior parts have been listed, cussed, and discussed here over and over.
And the usual response..........................I refer back to The Chart.
Only hits count......you can not miss fast enough to catch up
I am not a huge fan of Rock River. As a matter of fact all of my M4s are either Colt or Noveske, because I ONLY use quality products. I like BCM, not my favorite, but he was said he was trying to not spend a lot of money. Hell, if that is the case then get a complete LMT seen Here:
http://www.rainierarms.com/?page=sho...roduct_id=1040
It is only $250 more and comes with a sight also, and it is a LMT.
Last edited by docsherm; 10-05-09 at 22:06.
In no way do I make any money from anyone related to the firearms industry.
"I have never heard anyone say after a firefight that I wish that I had not taken so much ammo.", ME
"Texas can make it without the United States, but the United States can't make it without Texas !", General Sam Houston
I know of LMT's priced better than that, so I'm thinking of going that route, or the BCM middy.
Also have read good stuff about the CMMG middy for under $950.
I'm in no hurry. Thanks for the feedback.![]()
me too Cpecz. I"ve got one I'll put side beside the the best of them.I've bult my share over the years and with the quality parts I bought and my attention to detail during assembly.
I'm sure my M4 is almost as good if not better than most Colts or anything else for that matter.
Plus Trial by Fire.
It's been shot nearly 4000 rounds not a hiccup.I do use quality ammunition though.
I changed out at (3500 rnds) my BCM extractor spring ,Black insert and O ring with another just like it.'I put it in a bag I have for used parts that aint broke yet.
I'm setting a service schedule and keeping a list of what I change out and install and how many rounds were shot.
I want to be proactive instead of reactive.Just like when my bolt gets 10000 rounds on it I'm going to change it out whether it's broke or not.
Oh and I changed the gas rings out at 3000 rnds.
Get a Daniel Defense XV which blows away the S&W, RRA, and CMMG. You can find it for $999. Plus you then get a $250 DD blackcard gift card which let's you get anything DD. ( like an Omega rail).
Now that is a sweet deal and blows away the competition.
I have been very pleased with the DD. It is full mil-spec along with extras like: flared magwell, sweet buis, pmag, m16 bcg, CHF barrel, and lifetime warranty.
It's a NO-BRAINER!
VIOLENCE OF ACTION..........DON'T HESITATE.
Bookmarks