We would like to show some of the work that we do on lever action marlins. The guns in the pics are 16.5 inch guns from the factory however we do cut down marlins from time to time. We go thru the guns inside thy levee a little to be desired from the factory thy just are not finished. We dehorn the body and polish all the internals so the guns feel and function the way that thy shoed. Then we do sight work we use steel peep rear and front post sight. The guns are made for hard use so they must be over built just a little. Then we go to optics we use a scout rail on the guns and a lot of aim points. The T1 and H1 work very well for this application you can even get a light on an offset mount on the guns. Which is what brings me to post this when we travel up north this is the rifle that we take most often. More than one time we have had to travel in states were black rifles are not allowed. The fact of the matter is that nobody thinks that a lever gun will be used to defend one’s life so those in the politely correct states don’t think a thing of lever gun. When you put there stopping power and versatility up against most platforms thy do just fine for then selves. They are very thin and short carbines so they lend then selves to fighting guns if you know your history that was their first job.
Now for some before pics
After
The whole gun is bead blasted to cut down on glare and it just looks very clean.
WWW.SUPERIORFIREARMSLLC.COM
5510 Fern Valley RD. STE102
Louisville KY. 40228
502-365-2244
Bookmarks