Receiver Lock Plate Staking Tool?

[Lumpy196]

Because while a wrench tightened castle nut may hold for moderate range play, it wont under heavy use.


OMG...Tally. I just saw your initial post. - YOU WENT SOFT

[QUOTE= but its a chore to get it to not look like complete crap.

[/QUOTE]

[GIFFMANN]

I've been hesitant to use aluminum end plates like the Daniel Defense Burnse Loop, because I wasn't sure what would happen when I tried to stake it ( I don't trust Locktite for this). Has anybody had any experience staking aluminum end plates?

VLTOR makes a steel sling plate that is quite similar to the Burnsed Loop. Might be a good option for you.

[Aubrey]

Giff,
Roger that. I used the Vltor in lieu of the DD because it was steel. I got mine from WES, but I've yet to see them listed for sale by anyone.

[GIFFMANN]

Giff,
Roger that. I used the Vltor in lieu of the DD because it was steel. I got mine from WES, but I've yet to see them listed for sale by anyone.

I've actually got a couple of extra ones if you're needing. Not even sure of pricing as they are not on my price list, but I'll find out.

giff

[M193 BALL]

I used a small punch1/16 myself ! My VLTOR hasnt came loose yet.
Looks like LMT used the same size as well on my DEFENDER

[Harv]

Here is the stake job LMT did on My Defender Lower I just got recently

[M193 BALL]

My Defender/sopmod looks about the same.
Except not as deep?
maybe a Girl did it

BTW I also got the single sling adapt LMT sells wich turns out to be a TANGO
LMT lowers ROCK