Noveske Rifleworks Lowers

[xm15]

the rear pin had to be tapped in, it was VERY tight








was going to try it today but constant heavy rain so tomorrow may be the time

the only problem with this build is the rear take down pin and the ejection port door will not close unless tapped with a SOFT rubber mallet.the machining is a bit close. the parts are fine just tight tolerances I guess.

[C4IGrant]

Very nice!


C4

[SuicideHz]

My Noveske/MUR needs a punch for removing the rear takedown pin still. It's ridiculously tight but that's better than wobbly I guess!

[jackinfl]

Which Hammer and trigger parts are you guys putting in these lowers. More directly who's trigger hammer parts is COLT using?
Thanks in advance.

[EmanP]

I ordered mine direct from CMT/Stag. Only problem is they have a minimum order of $50 and it's only $35 worth of parts so you may as well stock up on spare parts.

[C4IGrant]

Which Hammer and trigger parts are you guys putting in these lowers. More directly who's trigger hammer parts is COLT using?
Thanks in advance.

I have been using CMT LPK's in the ones that I have built.


C4

[Cold Zero]

XM15;

That is a beautiful well thought out set up. I am sure it will serve you well.

[adh]

http://www.hunt101.com/img/367247.JPG
http://www.hunt101.com/img/391879.JPG

[xm15]

I had to send the MUR back to VLTOR so they could replace the door. now it is easy to close. the LPK came with it minus the trigger/butt stock.