CMMG/DD AR-15

[bp7178]

Built from parts. Got a good deal on a stripped CMMG upper and lower...about $2200 later here it is...



CMMG upper and lower (with CMMG LPK)
DD Cold Hammer Forged 16" Barrel
DD Complete Bolt Carrier Group
DD Carbine Gas Tube
DD A2 Flash Hider
Troy MRF 10" Free Float Rail
Troy Low Profile Gas Block
Troy Front (HK) and Rear BUIS
Magpul UBR Stock
Magpul MOE Grip
Magpul BAD
Magpul XTM Rail covers (plus ladder type)
Magpul AFG
Magpul PMAGS
American Defense 30mm Extended Mount (Dual Lever Type)
Leatherwood/Hi-Lux CMR 1-4x Scope

First range trip is monday...going to be fun.

[blackbox]

your weapon makes me want to build another one in all black! lookin' good there bp7178!!!

[bp7178]

Thanks. I figured if I ever got tired of it I could replace all the furniture with another color.

[opksrj]

cool

I really like those scope mounts

[chavez_e_chavez]

THAT IS ONE SWEET BLACK RIFLE!!!

[bp7178]

Fired off 120 rounds at a local indoor range w/o a problem. The rifle is very accurate, much more so than me at this point. They didn't have a rifle rest or anything, so I had to do the best I could.

The iron sights and scope were only a few (less than 5) clicks from being on at 25 yards. Both were set to be 1.5" low, so should be on or very close at 100 yards.

On that note, I moved the AFG back a bit, so more of the bottom rail is exposed forward of the AFG. Give me more real estate to rest the gun on, and I hope to get a QD bi-pod mount someday. Something I can take off and on as needed.

I also moved the scope forward one notch on the top rail.

Three round groups at 25 yards;



No rifle rest used, spread is under .5"...



I had used the red goop shipped with the ADM mount on the screws. I found that all of the scope mount screws had came loose by the end of my range session (2 hours...and 120 rounds). I cleaned them all off and used blue locktite. Will re-verify the zero soon.

Next thing to buy is a flashlight. I'm thinging X300 on the 9 o'clock rail with a pressure pad on the 12 o'clock...