Did I over torque the upper screws? The rail drops down a little from the receiver. Otherwise, everything else lines up great.
Did I over torque the upper screws? The rail drops down a little from the receiver. Otherwise, everything else lines up great.
Not sure i follow on the over torquing part but do you have a carry handle? Using one really helps keep things aligned while tightening/torquing the screws. A larue or adm scope mount might work too.
ETA: Crap. Thanks for pointing that out. Lol!
Last edited by Col_Crocs; 03-31-14 at 08:27.
MUR-1a. Its not off by much. It is just sitting a bit lower.
The bolt-up plate that sits behind the barrel nut on the RIS II should have enough vertical play while loose to attain proper alignment with the upper receiver's rail. Just loosen all 6 screws and move it upward a touch before tightening them down again.
Yeah just loosen them enough to push the rail up some and torque them back down. You have to play a little with them to get them lined up perfectly.
Bookmarks