Randall
any idea for Roll Pin Punch sizes and holders?
Thanks
|
||||||||||||||||||||||||||||||||||||||
Randall
any idea for Roll Pin Punch sizes and holders?
Thanks
The only roll pin holder that's been necessary enough for me to make is the 5/64" for gas tube pins and the 1/16" for charging handles.
Everything else is long enough that you can start them by holding them.
If you really like holders, just get 1/16, 5/64, 3/32, 1/8 & 5/32 and you will be better prepared than me.
I use needle-nose vice-grips to compress the roll pins a bit for starting them.
Bookmarks