Car 15

[ZRH]

This may illuminate: http://www.dtic.mil/cgi-bin/GetTRDoc...c=GetTRDoc.pdf

[dpaqu]

http://www.jsesurplus.com/militarysu...specifics.aspx

I just checked and it said there are still 15 left.

The last link was no good.

Duh. I did not see the option for slickside. My bad

[torquemada055]

http://98.196.65.94/retroblackrifle/index.html

That's where you go for the answers to the different models, what you have in the picture is a 604 upper. Since it's a mish-mash of parts that's obviously an A.F. carbine and would be listed as either a GAU or GUU model. The 603 uppers have a forward assist. The 605 uppers have the forward assist bump milled off the forging, you can see examples of these at nodakspuds website, along with the lower variations.

For parts you can get them at AR15.com in the Equipment Exchange, at http://98.196.65.94/retroblackrifle/phpBB3/index.php it's the forum page for RBR.
http://www.pkfirearms.com/ has a good selection of retro parts.
http://www.gunthings.com/ has kit's

Lastly for the Brick's moderator and grenade ring repro's he has an ad on RBR in the want to sell section.
Here's my wifes mocked up the day it came back from ADCO after having it cut, crowned, threaded and having the moderator and grenade ring perm installed. I forgot to have the bayonet lug and forge flash removed so it isnt an accurate clone. I also used the 607 handguards as they fit her small hands better than the round carbine handguards.

[uxb]

Go for the 10" upper with moderator.

[Tommel]

Go for the 10" upper with moderator.

You always have nice stuff UXB.

-Tom

[dpaqu]

Not to get to nerdy but is it accurate to have the sling attachment? I thought they were missing or ground off or somthing on the carbines.