Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14

Thread: Turkey Fryers - need some guidance

  1. #11
    Join Date
    May 2008
    Location
    nc
    Posts
    321
    Feedback Score
    0
    Quote Originally Posted by Todd.K View Post
    Spend the extra for a stainless pot.
    Yes, a stainless pot is a must. You wont have to worry about it staining, when you go to Tye-Dyeing your shirts ant pants

  2. #12
    Join Date
    Jul 2010
    Location
    Fayetteville, NC
    Posts
    2,055
    Feedback Score
    11 (100%)
    I've been frying turkeys for about 12 years now. I wouldn't do then any other way. About 4 years ago I got a Stainless kit from Sam's and it's still going strong. The most tedious part of the whole process is filtering out the oil to re-use and also disposing of old oil. Other than that the process is very easy.

    This is the best piece of advice I can think of with turkey frying. The best way to determine how much oil to use is to take your frozen turkey still in the wrap and put it into the empty fry pot. Fill up the pot with enought water to completely cover the bird and then pull out the bird. Mark the waterline after pulling out the bird and that will also be your fill line for adding the oil. Or course before you add any oil make sure to dry out your pot. I use 100% peanut oil and with filtering I can usually get 3-4 uses out of the batch of oil. After that it's pretty much useless. Unless you run a diesel truck then you can mix the filtered oil at about a gallon of oil to 12-15 gallons of diesel. My truck runs great with it. That's a side bar though.

    I always inject my birds the night before and let the marinade sit in the bird over night. I also cover the outside in cajun seasoning a couple of hours before frying. Get the oil temp to 350 degrees and cook you bird for about 3 to 3 1/2 minutes per pound. Once your time is up pull your bird out and your ready to carve it up. One last tip When you putting your bird in the oil make sure your wearing an oven mitt. The oil will be splattering up and you will get burnt if you don't wear a mitt. Also lower the bird very slowly so the splattring and splashing won't go all over the place. Once you get the bird in the oil should be covering all of the bird. The biggest bird I've done is right at 20lbs. That's the max my pot will hold.

    This is a small drawback but when frying you don't have any drippings to make gravy with.

  3. #13
    Join Date
    Dec 2007
    Location
    Fort Collins Colorado
    Posts
    2,672
    Feedback Score
    4 (100%)
    Quote Originally Posted by Skyyr View Post
    Blah. You guys are over-thinking this.

    Just get a big 50-gallon drum, fill it full of peanut oil, place it over a fire and let it heat for about 25 minutes.

    Then throw a frozen turkey in.
    everybody behind the blast shield

  4. #14
    Join Date
    Dec 2007
    Location
    Fort Collins Colorado
    Posts
    2,672
    Feedback Score
    4 (100%)
    I weber-grilled my turkey last thanksgiving. basically you put a drip pan under the grate, and put all the charcoal to the sides. came out good.

Page 2 of 2 FirstFirst 12

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •