LMT .308 MWS Pictures show us your setup

[J-Fonz]

Thanks for the info J-Fonz, this is really great news for me: would you kindly post here or PM me some pictures and share who did the milling/machine work for your LMT?

Old photo, it wears an ERS now. But it does show the rails.

[hk91308]

Old photo, it wears an ERS now. But it does show the rails.

Gorgeous, thanks very much...can you provide me the contact/source where I may send mine off to get this done?

[Boba Fett v2]

Gorgeous, thanks very much...can you provide me the contact/source where I may send mine off to get this done?

I'm interested as well.

J-Fonz, how much weight are you saving with the milled rail?

[J-Fonz]

The previous owner had the work done. Dobbs Defense in GA. I believe he said it was 6 or 7 ounces saved.

It sure does point nice.

[hjmpanzr]

The LM8 is still an ounce or two lighter than a milled chassis.





Bad pic but new Nightforce ATACR F1 5-25x

[Plasman]

The LM8 is still an ounce or two lighter than a milled chassis.

How? The difference between the weight of an MWS and LM8 upper chassis is only .8oz (I have both)...

[hk91308]

The LM8 is still an ounce or two lighter than a milled chassis.






Bad pic but new Nightforce ATACR F1 5-25x

Very nice, thanks. Where did you get your milling work done on the top receiver picture? Just my preference, I like the milled over LM8 slick models

[hjmpanzr]

I bought the chassis from ADCO. They said they did the work. It's good work.

[hjmpanzr]

How? The difference between the weight of an MWS and LM8 upper chassis is only .8oz (I have both)...

Well, either your scale or my scale is off.

[hk91308]

I bought the chassis from ADCO. They said they did the work. It's good work.

Thank you, I'll reach out to them and see if I can send mine in for the milling.