My CB-15 Limited Edition Build

[Rusty_Shackleford]

Upper:
Quentin Defense Billet Upper (Chatterbox Limited Edition)
DD CHF Govt. Profiled 14.5" Mid-Length
DD Omega X 9.0 Free Float Rail
DD A 1.5 BUIS
DD Charging Handle
BCM BCG (will replace with DD when they are available again)
BCM A2X (pinned and welded)
Larue Index Clips
Surefire X300
Built by ADCO

Lower:
Quentin Defense Billet Lower (Chatterbox Limited Edition)
DD Lower Parts Kit
DD Receiver Extension
DD H Buffer and Spring
DD Single Point End Plate
Armalite Adjustable 2 Stage Trigger
Ergo Sure Grip
RRA Ambi-Star Safety (will be replacing with BAD ASS)
Magpul CTR (may replace with SOPMOD)
Magpul PMAG
Built By Rusty

[ryr8828]

Beautiful.

[HaydenB]

Why would you want to replace the BCG?

[Rusty_Shackleford]

I wanted all DD built around the receivers and where I couldn't I used BCM. It was just a personal preference for this build. I have a few BCM's and I am very happy with them but I wanted something different for this one.......

[HaydenB]

I wanted all DD built around the receivers and where I couldn't I used BCM. It was just a personal preference for this build. I have a few BCM's and I am very happy with them but I wanted something different for this one.......

Cool, I guess that also explains why you went with a standard CH instead of a gunfighter.

P.S. Super nice stick.

[The_War_Wagon]

I want your BCM BCG when your DD arrives.

[Rusty_Shackleford]

I want your BCM BCG when your DD arrives.

Thanks guys!

[huntsimp]

Nice. I have a very similar setup.

How much did Adco charge for the assembly of the upper? Did you just tell them the components you wanted or did you ship them the stuff?

[Rusty_Shackleford]

Nice. I have a very similar setup.

How much did Adco charge for the assembly of the upper? Did you just tell them the components you wanted or did you ship them the stuff?

I sent them the stripped upper and BCM A2X and I purchased the barrel w/FSB, gas tube, and rail from them. (they were the only vendor that had all the parts in stock) Since I don't have the tools and have never built an upper before and seeing how they had the parts I needed it was just cheaper and faster to have them do it for me. The assembly charge was $35.00 and the pin and weld was $15.00. I could have done the pin and weld myself, I am a certified welder but I don't have access to a machine right now so I had them do that too.

They did a nice looking job and I got it back within a week so I am very satisfied so far. I plan on shooting it this weekend and will update on its functionality after that.........

[Flyer007]

I love the billet....the lines are great.

But man is that a huge ambi selector. I'm curious how you like it after running it for awhile.