9mm woes....

[redtazdog]

You obviously know what you are doing if you have to resort to diaper talk.

LOL LOL

[Robb Jensen]

I may only be a NooB here but I'am a oldy at Building and shooting guns
I was shooting guns when you were shooting yellow turds in your diaper.

Thanks and have a nice evening

That's enough of that redtazdog. Stay on topic.

[Madsmiley]

I dont think its the Haun block that holds the mag to high.
The mag catch hole is cut low in the mag.
The mag catch holds the mag in the lower not the 9mm adapter block.
I have 2 Haun 9mm blocks one of them is the first bottom load block the was made by haun and is all heavy steel that works just fine with the colt mags.
The other is his newest dedicated top load block that i just got from him a week ago and it works with the colt mags too.
I just purchased 5 CProducts mags and they sit just a little higher in the lower
than the colts.
If needed i will trim the mag catch hole in the mags to lower the mag if needed.

I had to trim all 3 of my C=Product mags.They set so high the upper wouldnt even close

Tried a couple of un-modded C-Product mags today and ran back into the original problem with the cases bouncing around inside..Belive these are the 2nd generation but not 100% certain.These seemed to seat correctly,just wouldn;t function reliably.

Also had to go back to the 9mm notched hammer as well as an unramped bolt due to some serious backpressure issues when running the Trident on it.Ran about 100rds thu it today..Not really enough to get a good feel for the current setup yet to see if this is gonna be the right setup..

[SuicideHz]

So you filed a little out of the top of the notch so they will sit lower?