I had to trim all 3 of my C=Product mags.They set so high the upper wouldnt even close
Tried a couple of un-modded C-Product mags today and ran back into the original problem with the cases bouncing around inside..Belive these are the 2nd generation but not 100% certain.These seemed to seat correctly,just wouldn;t function reliably.
Also had to go back to the 9mm notched hammer as well as an unramped bolt due to some serious backpressure issues when running the Trident on it.Ran about 100rds thu it today..Not really enough to get a good feel for the current setup yet to see if this is gonna be the right setup..
So you filed a little out of the top of the notch so they will sit lower?
Do not taunt Happy Fun Ball...
Bookmarks