Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Flash suppressor

  1. #11
    Join Date
    Jul 2009
    Location
    Socialist Republik of Kalifornia
    Posts
    409
    Feedback Score
    2 (100%)
    The solid section should be located at the 6 o'clock position with the wrench flats vertically oriented 90 degrees to the ground. The crush washer should allow almost 360 degrees of rotation but as mentioned, do not over-torque the device. If you are uncomfortable with the amount of rotation required to properly clock the device you should have a competent gunsmith install it or contact us through our website and we would be happy to assist you.
    Marty
    "Indecision is the key to flexibility"

  2. #12
    Join Date
    Dec 2009
    Location
    Utah
    Posts
    8,421
    Feedback Score
    3 (100%)
    When it takes nearly 360 degrees to time a muzzle device with a crush washer, is there anything wrong with tightening the device a little and backing it off to pre-crush the washer a little? That way, instead of having, say 270 degrees of torque, you have only around 90 degrees of final torque? That would place less stress on the threads and reduce distortion.

    CWard911, use a thin open end wrench, like a tappet wrench when installing the Battlecomp. A normal wrench is too thick and will damage the crush washer and the wrench will get stuck
    Last edited by MistWolf; 11-24-11 at 13:43.
    INSIDE PLAN OF BOX
    1. ROAD-RUNNER LIFTS GLASS OF WATER- PULLING UP MATCH
    2. MATCH SCRATCHES ON MATCH-BOX
    3. MATCH LIGHTS FUSE TO TNT
    4. BOOM!
    5. HA-HA!!

    -WILE E. COYOTE, AUTHOR OF "EVERYTHING I NEEDED TO KNOW IN LIFE, I LEARNED FROM GOLDBERG & MURPHY"

    http://i115.photobucket.com/albums/n289/SgtSongDog/AR%20Carbine/DSC_0114.jpg
    I am American

  3. #13
    Join Date
    Aug 2008
    Location
    West of the Atlantic
    Posts
    1,803
    Feedback Score
    0
    I hope your primary goal was not to decrease the flash signature of the rifle. The BC is not a flash hider.

Page 2 of 2 FirstFirst 12

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •