Improved AR15A2/A3/A4 & AR15 Carbine Zero Targets - 50/200M, 100M, & 300M Zeroes

[thecolter]

I have created a series improved 25M zero targets (based of the standard US Military 25M zero target) that will allow the shooter to zero for 50/200M, 100M, and 300M using a 25yd/M range. The diferent targets are calibrated for both 20" full length service rifles and also 14.5" / 16" carbines with the shorter sight radius. The bold centering lines should assist in aquiring the good sight picture required for zeroing. These are also in different colors in addition to the traditional black for your individual preference.

Trajectories used were an average of M193 and M855 ballistic data. This should get most shooters in the right area. As you know, this can change with different loads.


ZERO TARGETS FOR AR15A2 / A3 / A4 20" RIFLES USING IRON SIGHTS

50/200M Calibrated Zero Target w/ RIBZ Instructions


Colors:



100M Calibrated Zero Target w/ RIBZ Instructions


Colors:



Standard 300M Zero Target


Colors:



Target sets can be downloaded in .pdf format below:
50/200M Zero Target for 20" Rifle
100M Zero Target for 20" Rifle
Standard 300M Zero Target for 20" Rifle



TARGETS FOR 14.5" / 16" M4 & AR15 CARBINES USING IRON SIGHTS

50/200M Calibrated Zero Target w/ RIBZ Instructions


Colors:



100M Calibrated Zero Target w/ RIBZ Instructions


Colors:



Standard 300M Zero Target


Colors:



Target sets can be downloaded in .pdf format below:
50/200M Zero Target for 14.5"/16" Carbine
100M Zero Target for 14.5"/16" Carbine
Standard 300M Zero Target for 14.5"/16" Carbine




All targets are designed for standard 8.5"x11" paper. Make sure your page scaling is set to 'NONE' in your print settings for proper scaling.

Grid dimensions for targets are:
Rifle Targets: .96cm
Carbine Targets: 1.3cm


Be safe and good shooting!


Also check out these targets created primarily for use with Aimpoint style red dot / non-magnified optics. There is a 50 yard zero target and adjusted 25 yard target with zeros for 50/200M & 100M.



https://www.m4carbine.net/showthread.php?t=96955