O-rings can break too. Just leave it alone.
|
||||||||||||||||||||||||||||||||||||||
O-rings can break too. Just leave it alone.
“The practical success of an idea, irrespective of its inherent merit, is dependent on the attitude of the contemporaries." Nikola Tesla
Attachment 10975
this is what i'm talking about. you can see the LMT "ahem" doesn't cut corners... so to speak...![]()
so the original question was. does anyone know of any manufacturer of stripped upper receivers that looks like the LMT one on the right?
Based on the pictures from their web site White Oak Armament doesn't seem to have the bevel, but it is rounded. CMMG doesn't appear to have the bevel nor the rounded profile.
Not sure if it makes a difference when it comes to fit. Most likely the width of the block, location and tolerancing of the hole are more important.
LMT provides complete upper receivers for Barrett (who stamp their mark on it).
Should be around $95 shipped, which I find very hard to beat.
Link:
http://www.barrettrifles.com/Store/p...er,1133,62.htm
Good luck!
Dave
is the Barrett M468 upper receiver for the 6.8mm only???
Bookmarks