Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: New tool idea for dimpling barrels for set screwed low pro gas blocks

  1. #11
    Join Date
    Jan 2007
    Location
    Minnesota
    Posts
    162
    Feedback Score
    0
    Quote Originally Posted by gotm4 View Post
    I've seen some gas blocks that don't allow for the handguard cap.
    Interesting. What makes?

    As long as the hole pattern is the same, with the chamber end hole centered on the gas port, the jig would still work.
    Owner - BRD Engineering

  2. #12
    Join Date
    Jan 2007
    Location
    Minnesota
    Posts
    162
    Feedback Score
    0
    Quote Originally Posted by Hootiewho View Post
    Maybe off subject, but some of you might not know to do this. When tightening set screws on anything, torque it down, then back it off and torque it down again, as the 2nd time you will get more of a bite on the metal. It will hold better.

    One a gas block, I'd still pin it.
    Good point.
    Owner - BRD Engineering

Page 2 of 2 FirstFirst 12

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •