|
||||||||||||||||||||||||||||||||||||||
Last edited by C4IGrant; 02-16-12 at 12:10.
What size is the standed pin size like DD,LMT DPMS,CMT,STAG,Bushmaster and so on?
thanks Grant.
I really like Daniel Defense lpk's. The trigger and selector both operate crisply. DD also makes everything but the springs in-house.
One thing I've noticed about lesser quality lpk's is the hardness of the parts. After about 200 rounds on a bushmaster lpk i had, I noticed a small divot forming in the bolt catch where the bolt lugs run across it. The DD lpk I am currently using does not exhibit this divot after nearly 800 rounds.
B.A.S. Mechanical Engineering Technology
If you want the best, go with Colt. I've been ordering from Specialized Armament and getting just the parts I need since I always replace the mag catch, selector, and trigger anyway. Only downside with SA is the cost of shipping. It will cost you a little more but you could always go this route and then pick up one of the new ALG Defense triggers.
Got mine one from Grant and one from PSA. Can't really tell the difference other than the PSA one came with a weird looking safety selector and was cheaper. But I am a total noob.
Can't say anything negative about either to be honest.
..It was you to me who taught
In Jersey anythings' legal, as long as you don't get caught.
I'm not sure, but I heard Noveske uses Stag. I have a factory built Noveske w/Geissele SSA trigger. Good setup, or should I do something about it?
Stick
Board policy mandates I state that I shoot for BCM. I have also done work for 200 or so manufacturers within the firearm community. I am prior service, a full time LEO, firearm instructor, armorer, TL, martial arts instructor, and all around good guy.
I also shoot and write for various publications. Let me know if you know cool secrets or have toys worthy of an article...
Flickr Tumblr Facebook Instagram RECOILMAGAZINE OFF GRID RECOIL WEB
Bookmarks